Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
system_administration:manual_installation:1_basic_system [2020/07/26 12:34]
franzunix [Localization and GPIO pin]
system_administration:manual_installation:1_basic_system [2020/07/26 12:45] (current)
franzunix [GPIO: d-diot image v.1.4 and above]
Line 253: Line 253:
 ### d.diot settings ### d.diot settings
  
-# Enable serial+# Enable serial ​(uart1 = mainmcu, uart3 = RFLink, uart 5 = MySensors NRF24)
 enable_uart=1 enable_uart=1
 +dtoverlay=uart3
 +dtoverlay=uart5
  
 # Enable spi0 for MySensors RFM69 radio module and set the cs pins (GPIO pin 8 and 7 = PIN 24 and PIN 26) # Enable spi0 for MySensors RFM69 radio module and set the cs pins (GPIO pin 8 and 7 = PIN 24 and PIN 26)
 dtoverlay=spi0-cs,​cs0_pin=8,​cs1_pin=7 dtoverlay=spi0-cs,​cs0_pin=8,​cs1_pin=7
  
-# Enable ​spi1 for MySensors NRF24 radio module and set the cs pin (GPIO pin 16 = PIN 36+# Enable ​shutdown ​pin (GPIO pin 16 = PIN 36) 
-dtoverlay=spi1-1cs,​cs0_pin=16 +dtoverlay=gpio-shutdown,​gpio_pin=16,​active_low=1,​gpio_pull="​up"​
- +
-# Enable shutdown pin (GPIO pin 5 = PIN 29+
-dtoverlay=gpio-shutdown,​gpio_pin=5,​active_low=1,​gpio_pull="​up"​+
  
 # Enable poweroff pin (GPIO pin 6 = PIN 31) # Enable poweroff pin (GPIO pin 6 = PIN 31)
  • system_administration/manual_installation/1_basic_system.txt
  • Last modified: 2020/07/26 12:45
  • by franzunix