Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
how_to:mysensors:firmware_upload [2019/11/11 20:51]
franzunix
how_to:mysensors:firmware_upload [2019/11/11 20:52] (current)
franzunix
Line 5: Line 5:
 To flash an Aduino Pro Mini or directly an ATMega MCU, like the one present in some PCB of this project, you need an FTDI adapter. ​ To flash an Aduino Pro Mini or directly an ATMega MCU, like the one present in some PCB of this project, you need an FTDI adapter. ​
  
-[{{ :​how_to:​mysensors:​ftdi:​ftdi.jpg?​direct&​400 | FTDI adapter with selectable voltage (3.3V and 5V}}]+[{{ :​how_to:​mysensors:​ftdi:​ftdi.jpg?​direct&​400 | FTDI adapter with selectable voltage (3.3V and 5V)}}]
  
 Since d-diot image v.1.1 you can use your d-diot hub to flash your Arduino board, but only if the firmware is built with [[https://​platformio.org/​|PlatformIO]],​ like the ones present in the [[https://​github.com/​d-diot|d-diot github repository]].  ​ Since d-diot image v.1.1 you can use your d-diot hub to flash your Arduino board, but only if the firmware is built with [[https://​platformio.org/​|PlatformIO]],​ like the ones present in the [[https://​github.com/​d-diot|d-diot github repository]].  ​
  • how_to/mysensors/firmware_upload.txt
  • Last modified: 2019/11/11 20:52
  • by franzunix