Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
how_to:atmega2560:upload_rflink_firmware [2020/07/26 19:11]
franzunix [d-diot image v.1.4 and above]
how_to:atmega2560:upload_rflink_firmware [2020/07/26 19:13] (current)
franzunix [d-diot image v.1.4 and above]
Line 33: Line 33:
 ===== d-diot image v.1.4 and above ===== ===== d-diot image v.1.4 and above =====
  
-Set the jumper 4 fo the DIP switch to ON and the jumpers 3 and 5 to OFF, then ppload ​the RFLink firmware+Set the jumper 4 fo the DIP switch to ON and the jumpers 3 and 5 to OFF, then upload ​the RFLink firmware
 <cli> <cli>
-pi@d-diot:~ $ avrdude -v -p atmega2560 -c wiring -P /dev/serial0 ​-b 115200 ​-D -U flash:​w:/​home/​pi/​atmega2560/​rflink/​RFLink.cpp.hex:​i+pi@d-diot:~ $ avrdude -v -p atmega2560 -c wiring -P /dev//​dev/​ttyAMA1 ​-b 38400 -D -U flash:​w:/​home/​pi/​atmega2560/​rflink/​RFLink.cpp.hex:​i
 </​cli>​ </​cli>​
 To exit, if something goes wrong, press CTRL + ALT + c To exit, if something goes wrong, press CTRL + ALT + c
 +
 +Set the jumper 4 fo the DIP switch to OFF and restart home assistant
 +<cli>
 +pi@d-diot:/​home/​pi/​atmega2560/​arduino-mk $ sudo systemctl start home-assistant@homeassistant
 +</​cli>​
  
 [<>] [<>]
  • how_to/atmega2560/upload_rflink_firmware.txt
  • Last modified: 2020/07/26 19:13
  • by franzunix