Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
getting_started:hub_v2.0:2_assembly_the_board [2019/10/19 18:06]
franzunix [Final result]
getting_started:hub_v2.0:2_assembly_the_board [2020/05/24 13:15] (current)
franzunix [Top]
Line 1: Line 1:
-====== Assembly the board ======+====== Assembly the board and the case ====== 
 + 
 +===== d-diot board v.2.0 =====
  
 Follow the [[getting_started:​hub_v1.0:​2_assembly_the_board|instruction for the board v.1.0]]. Follow the [[getting_started:​hub_v1.0:​2_assembly_the_board|instruction for the board v.1.0]].
  
  
-<​jumbotron>​Use the [[http://​assembly.d-diot.com/​hub/​v2.0/​|interactive BOM tool]] to see where to place each component</​jumbotron>​+<​jumbotron>​Use the [[http://​assembly.d-diot.com/​hub/​v2.0/​|interactive BOM tool]] to see where to place each component ​in the d-diot board v.2.0</​jumbotron>​ 
 + 
 + 
 +===== 3d printable case ===== 
 + 
 +==== Bottom ==== 
 + 
 + 
 +  * Fix the 4 support to the bottom part of the case with 4 M2.5 screws 
 + 
 +  * Fix the Raspberry Pi 3 to the bottom part of the case with 4 M2.5 screws 
 + 
 +  * Install the fan in the bottom part of the case using the 4 screws (generally they are in bundle with the fan) 
 +    
 +{{gallery>:​getting_started:​hub_v2.0:​bottom?​0&​crop&​lightbox}} 
 + 
 + 
 +==== Middle ==== 
 + 
 +  * Install the middle part on top of the bottom part (snap fit) 
 + 
 +  * Solder two wires to the IR Led 
 + 
 +  * Place the IR led in its slot and fix it with hot glue 
 + 
 +  * Connect the fan and IR led to their connectors in the d-diot board 
 + 
 +  * Place the d-diot board inside the case 
 + 
 +{{gallery>:​getting_started:​hub_v2.0:​middle?​0&​crop&​lightbox}} 
 + 
 +==== Top ==== 
 + 
 +  * Install the oled display in its slot and fix with tape 
 + 
 +  * Connect the oled diplay to the header of the d-diot board 
 + 
 +  * Install the NRF24L01 radio module and close the case with the top part (snap fit)
  
 +  * Place the led cover part on the top part and... finish!
  
 +{{gallery>:​getting_started:​hub_v2.0:​top?​0&​crop&​lightbox}}
 +===== Final result =====
  
 +{{gallery>:​getting_started:​hub_v2.0:​final?​0&​crop&​lightbox}}
  
  
 [<>] [<>]
  • getting_started/hub_v2.0/2_assembly_the_board.1571508376.txt.gz
  • Last modified: 2019/10/19 18:06
  • by franzunix