Assembly the board and the case

Follow the instruction for the board v.1.0.

Use the interactive BOM tool to see where to place each component in the d-diot board v.2.0

Bottom

  • Fix the 4 support to the bottom part of the case with 4 M2.5 screws
  • Fix the Raspberry Pi 3 to the bottom part of the case with 4 M2.5 screws
  • Install the fan in the bottom part of the case using the 4 screws (generally they are in bundle with the fan)

Middle

  • Install the middle part on top of the bottom part (snap fit)
  • Solder two wires to the IR Led
  • Place the IR led in its slot and fix it with hot glue
  • Connect the fan and IR led to their connectors in the d-diot board
  • Place the d-diot board inside the case

Top

  • Install the oled display in its slot and fix with tape
  • Connect the oled diplay to the header of the d-diot board
  • Install the NRF24L01 radio module and close the case with the top part (snap fit)
  • Place the led cover part on the top part and… finish!

  • getting_started/hub_v2.0/2_assembly_the_board.txt
  • Last modified: 2020/05/24 13:15
  • by franzunix