Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
getting_started:hub_v1.0:2_assembly_the_board [2019/06/05 18:46]
franzunix [Set the output voltage of the regulators]
getting_started:hub_v1.0:2_assembly_the_board [2019/06/06 21:53] (current)
franzunix [Set the output voltage of the regulators]
Line 24: Line 24:
  
 ===== Set the output voltage of the regulators ===== ===== Set the output voltage of the regulators =====
 +
 +==== MP1584 ====
  
 Before you start soldering parts, it is convenient to regulate the output voltage of the MP1584 step down voltage regulator and MT3608 step up voltage regulator. Before you start soldering parts, it is convenient to regulate the output voltage of the MP1584 step down voltage regulator and MT3608 step up voltage regulator.
Line 35: Line 37:
  
 If you your LEDs configuration require 5V, you can power that simply not installing the MP1584 and then bridging the input + and output + holes of the footprint with a wire. If you your LEDs configuration require 5V, you can power that simply not installing the MP1584 and then bridging the input + and output + holes of the footprint with a wire.
 +
 +==== MT3608 ====
 +
  
 The scope of the MT3608 step up voltage regulator is to power The FS1000A 433 MHz transmitter ([[sensors_and_actuators:​rflink:​start|RFLink]]). ​ The scope of the MT3608 step up voltage regulator is to power The FS1000A 433 MHz transmitter ([[sensors_and_actuators:​rflink:​start|RFLink]]). ​
  • getting_started/hub_v1.0/2_assembly_the_board.txt
  • Last modified: 2019/06/06 21:53
  • by franzunix