This is an old revision of the document!

Getting started

Well… the first step to start with d-diot is to build your own hub.

At the moment this step requires a discrete amount of your time, because a pre-soldered board is not yet available, but the building process is part of the fun and following the steps of the guides it is not a so difficult task!

On the other side the software part is easy, simply download the d-diot image and burn it to an SD card.

  • getting_started/start.1557176791.txt.gz
  • Last modified: 2019/05/06 21:06
  • by franzunix